5V DIY Dot Matrix Digit LED Electronic Clock Kit Temperature 24 Hours Display
- List PriceUS$12.49piece
- Sale PriceUS$12.49piece
- ShippingFree Shipping
Code explanation and hardware analysis for basic lessons,these are VERY IMPORTANT for beginner.
Hardware overview include technical characteristics, operating principles, instructions on how to connect to Arduino
About the UNO:
This UNO is manufactured using the Creative Commons files provided on the Arduino website, therefore it is not manufactured by Arduino but is fully compatible with Arduino software(IDE) in every way and COST MUCH LESS!
We tested before shipment.
Add A6 and A7 analog I/O.
Add two rows of the pass-thru holes for connecting normal dupont line.
Come with SHIELD 50CM LONG USB cable for stable data transit.
1 x UNO R3 Mainboard
1 x USB Cable
1 x 830 Tie Points Breadboard
1 x 1602 LCD Display
1 x IIC module for 1602 LCD display ( need soldering work)
1 x 10k Trimpot Adjustable Resistor Potentionmeter
1 x MAX7219 Chip
1 x 8*8 Dot Matrix Display
1 x 5mm LED Assorted Kit (Red/Green/Yellow 5pcs each)
1 x PS2 Joystick Module
1 x Eight-segment Display (1-digit Common Cathode)
1 x Eight-segment Display (4-digit Common Anode) with clock
1 x IC L293D
2 x DC Motors
1 x SMD RGB Module
3 x 6*6mm Push Button Switches
1 x Buzzer 5v (passive)
10 x 220Ω Resistors
5 x 10KΩ Resistors
30 x Jumper Wires
1 x 10pin Dupont Lines (Female to Male)
1 x 2.54mm Straight 40 Pin Header
1 x 2.54mm Elbow 40 Pin Header
1 x DC 9v Battery Button Cable